HydroTAC Antimicrobial Filter Cartridge

$119.00

Advancements in filtration technology have led to this innovative filtration cartridge that reduces or removes bacteria, viruses, and cysts from your water source so that your whole home is guarded. No maintenance required. This filter acts as a Broad-Spectrum Particle Magnet, featuring a thermally bonded blend of microglass fibers and cellulose infused with Nanoalumina fibers in a non-woven matrix. Using NASA-derived technology, it can adsorb virtually any particle size with a unique combination of efficiency, capacity, flow rate and low pressure drop unlike its competitors. Protecting your home for up to 75,000 gallons before replacement is necessary. Use this in place of our 20 micron radial flow carbon cartridge for protection against viruses and bacteria!

Category:

Description

Antimicrobial Capabilities & More…

  • Removes up to or more than 99.99% of Bacteria, Virus, and Cysts
  • NASA-derived technology
  • Greater dirt holding capacity – 100x greater than other conventional filters
  • Pleated construction yields high flow rates and low pressure drop
  • Minimizing the risk of Legionella by adhering to national guidance
  • Lasts for up to 75,000 gallons of water!
Filtration Power that Competes with Top Technologies on the Market!
Contaminants HydroTAC® Antimicrobial Filter RO Particulate
Cartridges		 Carbon
Block		 Ultra
Violet
Bacteria

⊗

×

×
Bromine

×
Chemical Reduction

×

×
Chromium VI

⊗

×
Colloids

⊗

×

×

×
CTO

×
Cysts

⊗

×

×

×

×
Dissolved Salts

×
Endotoxins

⊗

×
Ferric Iron

⊗

×
Iodine
LEAD

⊗

×

×
Particulates

⊗

×

×

×
Polysaccharides (TEP)

⊗

×
Silica

⊗

×
Trace Pharmaceuticals

⊗

×

×
Virus / E. Coli / MS-2

⊗

×

×
VOC

⊗

×

An Effective Duo...

This antimicrobial filter, featuring nano-ceramic technology, in combination with our TAC® filter, can render biologically safer water with the added benefit of scale prevention that will keep your water heating appliances working longer. Unlike an RO membrane that tend to foul quickly, this HydroTAC® duo has high dirt-holding and flow capacity without the need for daily maintenance or backwashing! 

SPECIFICATIONS

Rated Flow Maximum 10 gpm (37.8 lpm)
Working Temp 40 – 104 °F (5 – 40 °C)
Terminal Pressure Drop 35 psi (2.4 bar); see other filter specs for more details.
Working Conditions For indoor use – protection required when installed outdoors.
Size 5.5 in x 5.5 in x 13.25 in (140 mm x 140 mm x 337 mm)
Min Net Weight 1.2 lbs (0.55 kg)
Contaminants Reduced Scale, Sediment, Other Chemicals (See Table Above)

CONDITIONS FOR USE

pH 6.5 to 8.5
Max Hardness 75 grains per gallon
Chlorine < 3 ppm
Iron, Ferrous ≤ 0.3 mg/L
Manganese ≤ 0.05 mg/L
Copper ≤ 1.3 mg/L
Oil & Phosphates Zero*
Hydrogen Sulfide Zero*

*Must be removed prior to HydroTAC®.

NOTICE: New copper should be used for a minimum of one month before placing the unit into service.

NOTICE: Untreated private well water may contain contaminants with levels outside of the operating guidelines. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

LEAD FREE*: The wetted surface of this product contacted by consumable water contains less than 0.25% of by weight.

Additional information

Weight 2 lbs
Dimensions 6 × 6 × 14 in

There are no reviews yet.

Be the first to review “HydroTAC Antimicrobial Filter Cartridge”

Related products